Connecting Your iPP320 to a Network

Overview

This article will walk you through the steps involved in connecting an Ingenico iPP320 chip reader to a network.

Unboxing

You should receive the following when you order your iPP320:
mceclip0.png

Step 1

The first step is to connect the Ethernet end of the Network Cable to your router. This can be done directly, or through a network switch:

mceclip2.png  mceclip1.png

Step 2

After connecting the Ethernet end of the Network Cable to a router or network switch, connect the other end of the cable directly to the back of the iPP320:

mceclip0.png  mceclip1.png

Step 3

The third step will be to plug the Power Adapter into the plug on the Network Cable:

mceclip2.png  mceclip3.png

Step 4

Once everything is connected, you are ready to plug the Power Adapter into an outlet and power on the iPP320. The chip reader should now be connected to the internet and is ready to be activated. Your next steps will vary based on your credit card processor:
mceclip4.png  mceclip5.png

Please contact support by calling (916) 226-4062 or sending an email to support@partycentersoftware.com for assistance regarding activating your chip reader in Party Center Software.

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.